A&P oral questions / Airframe

Water and Waste Systems: A&P oral exam questions

4 practice questions with answers for the Water and Waste Systems subject (AM.II.O) of the FAA Aviation Mechanic Airframe oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.

AM.II.O.K1 · Knowledge · Potable water system components and operation

On a transport aircraft, where does the potable water system deliver its water?

What the examiner listens for
  • From the potable water tanks through water linesbonus
  • To the lavatories and the galleys

A good answer: Water lines carry water from the potable water tanks to the lavatories and the galleys.

Likely follow-up: What has to be done to those water lines for operation in freezing temperatures?

Reference: FAA-H-8083-31B Ch. 15, Water & Waste Tank Ice Prevention

AM.II.O.K2 · Knowledge · Lavatory waste system components and operation

What do the waste water tanks on a transport aircraft collect, and which waste system parts are commonly electrically heated?

What the examiner listens for
  • Waste from the lavatories
  • The handbook also names gray water from the galleysbonus
  • Waste drain lines, drain masts, tank rinse fittings and drain hoses are heatedbonus
  • Heating prevents ice from blocking the linesbonus

A good answer: The waste tanks collect the waste from the lavatories; the handbook also names gray water from the galleys, though on many aircraft that drains overboard through heated drain masts. The waste drain lines, tank rinse fittings, drain hoses and drain masts are commonly heated with blankets, inline heaters or boots so ice cannot form.

Likely follow-up: What fittings on a waste tank are used when it is serviced on the ground?

Reference: FAA-H-8083-31B Ch. 15, Water & Waste Tank Ice Prevention

AM.II.O.K3 · Knowledge · Inspection and servicing requirements for water and waste systems

When you inspect the structure around a lavatory, where do you look and what are you looking for?

What the examiner listens for
  • Spillage and corrosion
  • The floor area and the areas behind and under the lavatory
  • Bilge areas below the lavatorybonus

A good answer: Inspect around the lavatory for spillage and corrosion, paying particular attention to the floor and the areas behind and under the unit, including the bilge below it.

Likely follow-up: Why do spilled fluids there lead to corrosion even if they are not corrosive themselves?

Reference: AC 43.13-1B, para 6-66

AM.II.O.R1 · Risk management · Servicing lavatory waste systems, including use of safety equipment

Besides the health hazard, why must lavatory waste spilled on the aircraft structure during servicing be cleaned up right away?

What the examiner listens for
  • The waste is corrosive to the airframe structure (it contains organic acids)
  • Spills also hold moisture against the structurebonus

A good answer: Human waste contains organic acids, and acids severely corrode most airframe alloys. A spill left in place also holds moisture, so it must be cleaned up and the area neutralized promptly.

Likely follow-up: Where would you expect to find that kind of corrosion on an older aircraft?

Reference: FAA-H-8083-30B Ch. 8, Common Corrosive Agents

These are 4 of the 8 questions MockDME has for this subject. The other 4 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.

Get the app when it launches

MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.

We use your address only for this one launch email and delete it afterwards. Privacy policy.

Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.

All 40 subjects