A&P oral questions / Powerplant
Turbine Engines: A&P oral exam questions
5 practice questions with answers for the Turbine Engines subject (AM.III.B) of the FAA Aviation Mechanic Powerplant oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.
How does a gas turbine engine produce thrust?
What the examiner listens for
- It accelerates a mass of air rearward
- The reaction to that acceleration pushes the aircraft forward, Newton's third law
- Air is compressed, heated by burning fuel, then expanded through the turbine and exhaust nozzlebonus
A good answer: A turbine engine takes in air, compresses it, adds heat by burning fuel, and expands the hot gas through the turbine and exhaust nozzle. Accelerating that mass of air rearward is the action, and the equal and opposite reaction on the aircraft is thrust, per Newton's third law.
Likely follow-up: What is the name of the thermodynamic cycle a gas turbine engine operates on?
Reference: FAA-H-8083-32B Ch. 1, Turbine Engine Operating Principles
What is the job of the turbine section in a gas turbine engine?
What the examiner listens for
- It extracts energy from the hot gases leaving the combustion section
- It converts that energy to mechanical power to drive the compressor and accessories
- Additional turbine stages can drive a fan, propeller, or output shaftbonus
A good answer: The turbine takes part of the energy of the hot exhaust gases and turns it into mechanical energy to drive the compressor and accessories. Extra turbine stages can drive a fan, a propeller, or an output shaft.
Likely follow-up: What are the two basic elements of a turbine assembly?
Reference: FAA-H-8083-32B Ch. 1, Turbine Section
What are you looking for when you inspect turbine blades in the hot section?
What the examiner listens for
- Stress rupture cracks, fine hairline cracks at right angles to the leading or trailing edge
- Deformation of the leading edge from overtemperature, such as wavinessbonus
- Use a strong light and magnifying glassbonus
A good answer: With a strong light and a magnifying glass, I look for stress rupture cracks, which are tiny hairline cracks across the leading or trailing edge at right angles to the edge, and for leading edge deformation such as waviness caused by overtemperature.
Likely follow-up: What usually causes waviness along the leading edge of a turbine blade?
Reference: FAA-H-8083-32B Ch. 10, Turbine Blade Inspection
A turbine engine comes out of storage with its fuel system preserved. What has to be done to the fuel system before the engine is run?
What the examiner listens for
- The preservative oil must be completely flushed out of the fuel system
- This is done by motoring the engine and bleeding the fuel systembonus
- Follow the manufacturer's depreservation instructionsbonus
A good answer: The fuel system, including the fuel control, is normally filled with preservative oil for storage. Before return to service that oil must be completely flushed out by motoring the engine and bleeding the fuel system, following the manufacturer's instructions.
Likely follow-up: What could happen on the first start if preservative oil were left in the fuel system?
Reference: FAA-H-8083-32B Ch. 8, Preservation & Depreservation of Gas Turbine Engines
What is a hot start on a turbine engine, and what do you do if you see one developing?
What the examiner listens for
- Exhaust gas temperature exceeds the starting limit
- Abort the start by shutting off the fuel
- Watch EGT continuously during every startbonus
A good answer: A hot start is when the exhaust gas temperature exceeds the starting limit. I watch EGT constantly during the start and, if it is heading over the limit, abort the start by shutting off the fuel. The overtemperature then has to be reported and the engine inspected per the manual.
Likely follow-up: What is a hung start?
Reference: FAA-H-8083-32B Ch. 10, Turbine Engine Operation
These are 5 of the 21 questions MockDME has for this subject. The other 16 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.
Get the app when it launches
MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.
We use your address only for this one launch email and delete it afterwards. Privacy policy.
Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.