A&P oral questions / General

Physics for Aviation: A&P oral exam questions

8 practice questions with answers for the Physics for Aviation subject (AM.I.J) of the FAA Aviation Mechanic General oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.

AM.I.J.K1 · Knowledge · Matter and energy

What is the difference between mass and weight?

What the examiner listens for
  • Mass is the quantity of matter in an objectbonus
  • Weight is the pull of gravity acting on that mass
  • Mass does not change with location; weight doesbonus

A good answer: Mass is a measure of the quantity of matter in an object and stays the same wherever the object is. Weight is the pull of gravity acting on that mass.

Likely follow-up: How is mass related mathematically to weight and the acceleration due to gravity?

Reference: FAA-H-8083-30B Ch. 5, Mass & Weight

AM.I.J.K3 · Knowledge · Simple machines and mechanics

What does mechanical advantage mean, and what do you give up when a machine multiplies force?

What the examiner listens for
  • It is the ratio of output force to input force
  • A gain in force is paid for with a loss in distance or speed
  • A machine cannot put out more work than is put inbonus

A good answer: Mechanical advantage is the comparison of output force to input force. If a machine multiplies force, it loses distance or speed in the same proportion, because no machine can deliver more work than is put into it.

Likely follow-up: Name the six simple machines.

Reference: FAA-H-8083-30B Ch. 5, Mechanical Advantage of Machines

AM.I.J.K4 · Knowledge · Heat and pressure

What is differential pressure, and where on an aircraft would a mechanic see it used?

What the examiner listens for
  • The difference between pressures at two different locations in a system
  • Examples: across an oil filter, or cabin pressure versus outside pressurebonus

A good answer: Differential pressure is the difference between the pressures read at two points in a system. Examples are the pressure drop across an oil filter, which grows as the filter clogs, and cabin differential pressure between the inside and outside of a pressurized airplane.

Likely follow-up: What happens to the pressure drop across a filter as it begins to clog?

Reference: FAA-H-8083-30B Ch. 5, Differential Pressure

AM.I.J.K7 · Knowledge · Gas law and fluid mechanics

An oxygen bottle is left sitting in the hot sun. What happens to the pressure inside, and which gas law explains it?

What the examiner listens for
  • The pressure increases
  • With volume constant, pressure rises in proportion to absolute temperature
  • The handbook calls this Charles' law (also known as Gay-Lussac's law); the general gas law is also acceptablebonus

A good answer: The pressure rises. With the volume fixed, the pressure of a gas changes in direct proportion to its absolute temperature; that is Charles' law, part of the general gas law.

Likely follow-up: What temperature scale must you use in that calculation?

Reference: FAA-H-8083-30B Ch. 5, Charles’ Law

AM.I.J.K9 · Knowledge · Standard atmosphere and factors affecting atmospheric conditions

What happens to atmospheric pressure and air density as altitude increases, and why does density fall even though the air also gets colder?

What the examiner listens for
  • Pressure decreases with altitude
  • Density decreases with altitude
  • Pressure drops faster than temperature doesbonus

A good answer: Both pressure and density decrease as altitude increases. Colder air would tend to be denser, but pressure falls off more rapidly with altitude than temperature does, so the net result is lower density.

Likely follow-up: How does humidity affect the density of air?

Reference: FAA-H-8083-30B Ch. 5, Atmospheric Density

AM.I.J.K10 · Knowledge · Primary and secondary aircraft flight controls

How does a balance tab move relative to its control surface, and what does that do for the pilot?

What the examiner listens for
  • It moves in the opposite direction to the control surface's trailing edge
  • It creates a force that helps move the control surface, reducing pilot effort
  • An anti-servo tab does the opposite, moving the same way to resist movementbonus

A good answer: A balance tab moves in the opposite direction to the trailing edge of the control surface. The air load on the tab helps move the surface, so the pilot needs less force.

Likely follow-up: How does an anti-servo tab on a stabilator move, and what is it for?

Reference: FAA-H-8083-30B Ch. 5, Balance Tab

AM.I.J.K12 · Knowledge · Relationship between temperature, density, weight, and volume

How does the density of a gas change with pressure?

What the examiner listens for
  • Density increases in direct proportion to the pressure on the gas
  • Temperature and pressure must both be considered for gas densitybonus

A good answer: The density of a gas increases in direct proportion to the pressure exerted on it, which is why both pressure and temperature have to be stated when you give a gas density.

Likely follow-up: At the same pressure, is hot air more or less dense than cool air?

Reference: FAA-H-8083-30B Ch. 5, Density

AM.I.J.R2 · Risk management · Effect a repair can have on a flight surface

You repair or repaint a control surface. What aerodynamic risk does that create, and what must you do about it?

What the examiner listens for
  • Added weight, especially aft of the hinge line, upsets the surface's balance
  • An out-of-balance surface can flutterbonus
  • Check and rebalance the surface per the manufacturer's instructions

A good answer: A repair or new paint can add weight aft of the hinge line and put the control surface out of balance. An unbalanced surface can flutter, in extreme cases to the point of losing the aircraft, so the balance must be checked and the surface rebalanced per the manufacturer's manual.

Likely follow-up: Is a trailing-edge-heavy surface or a nose-heavy surface the dangerous condition?

Reference: FAA-H-8083-31B Ch. 2, Rebalancing of Control Surfaces

These are 8 of the 48 questions MockDME has for this subject. The other 40 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.

Get the app when it launches

MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.

We use your address only for this one launch email and delete it afterwards. Privacy policy.

Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.

All 40 subjects