A&P oral questions / Airframe

Flight Controls: A&P oral exam questions

8 practice questions with answers for the Flight Controls subject (AM.II.C) of the FAA Aviation Mechanic Airframe oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.

AM.II.C.K1 · Knowledge · Control cables

What does the designation 7 by 19 tell you about a control cable, and where is that cable used?

What the examiner listens for
  • Seven strands of 19 wires each
  • It is very flexiblebonus
  • Used in primary control systems and where the cable runs over pulleysbonus

A good answer: A 7 by 19 cable has seven strands of 19 wires each. It is very flexible and is used in primary flight control systems and wherever the cable works over pulleys.

Likely follow-up: Where would you expect to find 7 by 7 cable?

Reference: FAA-H-8083-31B Ch. 2, Cable designations

AM.II.C.K2 · Knowledge · Control cable maintenance

Why should you not clean control cables by soaking them with solvent?

What the examiner listens for
  • Solvent removes the internal lubricant
  • The strands then abrade against each other and corrodebonus

A good answer: Solvents remove the lubricant inside the cable, which lets the strands abrade and corrode. After cleaning, a corrosion-preventive compound is applied sparingly.

Likely follow-up: Does corrosion-resistant steel cable need rust-preventive treatment?

Reference: AC 43.13-1B, para 7-149

AM.II.C.K4 · Knowledge · Cable guides

What do pulleys do in a cable system, and what keeps the cable from coming off them?

What the examiner listens for
  • Pulleys guide cables and change the direction of cable movement
  • Close-fitting guards keep the cable in placebonus

A good answer: Pulleys guide the cables and change the direction of cable movement. Guards fitted close to the pulley keep the cable from jumping off or jamming if it goes slack.

Likely follow-up: What can abnormal wear patterns on a pulley tell you?

Reference: FAA-H-8083-31B Ch. 2, Cable Guides

AM.II.C.K6 · Knowledge · Push-pull tubes

What do you check on a push-pull rod when you install or inspect it?

What the examiner listens for
  • Names at least one of: the rod is straight, the checknuts are tight, or correct alignment and free movement
  • Tight checknuts keep the rod ends from looseningbonus

A good answer: The rod should be perfectly straight unless designed otherwise, the checknuts on the rod ends must be tight, and the installed assembly should be checked for correct alignment and free movement.

Likely follow-up: What is the purpose of the checknut on the rod end?

Reference: FAA-H-8083-31B Ch. 2, Push Rods (Control Rods)

AM.II.C.K10 · Knowledge · Rigging of aircraft flight controls

What are the three general steps in rigging a flight control system?

What the examiner listens for
  • Lock the flight deck control, bellcranks and surfaces in neutral
  • Adjust cable tension with everything held in neutral
  • Adjust the control stops to give the specified surface travelbonus

A good answer: First lock the flight deck controls, bellcranks and control surfaces in neutral. Then adjust the cable tension while holding neutral. Finally adjust the control stops to limit the surface travel to the specified values.

Likely follow-up: What do you use to measure control surface travel?

Reference: FAA-H-8083-31B Ch. 2, Control Surface Travel

AM.II.C.K12 · Knowledge · Other aerodynamic wing features

What is a winglet, and what does it do?

What the examiner listens for
  • A near-vertical upturn of the wing tipbonus
  • It reduces the drag caused by wing tip vortices

A good answer: A winglet is a vertical upturn of the wing tip. It is an aerodynamic device that reduces the drag created by wing tip vortices.

Likely follow-up: What is the purpose of a stall fence?

Reference: FAA-H-8083-31B Ch. 1, Other Wing Features

AM.II.C.K13 · Knowledge · Secondary and auxiliary control surfaces

What do spoilers do, and how can they assist the ailerons?

What the examiner listens for
  • They rise into the airstream and reduce lift
  • The spoiler on the wing with the up aileron rises to help rollbonus
  • Deployed on both wings they act as speed brakesbonus

A good answer: Spoilers rise from the upper wing surface and disrupt the airflow, reducing lift. For roll, the spoilers rise on the wing whose aileron goes up; deployed on both wings together they act as speed brakes.

Likely follow-up: What are leading edge slats for?

Reference: FAA-H-8083-31B Ch. 1, Spoilers & Speed Brakes

AM.II.C.R3 · Risk management · Selection and use of lifting equipment used to move aircraft components into place for assembly

Before you use a hoist and sling to lift a heavy assembly into position, what do you check?

What the examiner listens for
  • Names at least one of: the hoist has enough capacity for the load, or the sling and hoist are in good condition
  • Account for the center of gravity of the loadbonus

A good answer: Inspect the sling, hoist and frame for condition, make sure the hoist has sufficient capacity for the weight, and take the load's center of gravity into account so it lifts level and under control.

Likely follow-up: How do you keep the load from swinging while it is being raised?

Reference: FAA-H-8083-32B Ch. 8, Hoisting and Frame Assemblies

These are 8 of the 36 questions MockDME has for this subject. The other 28 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.

Get the app when it launches

MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.

We use your address only for this one launch email and delete it afterwards. Privacy policy.

Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.

All 40 subjects