A&P oral questions / Airframe
Environmental Systems: A&P oral exam questions
8 practice questions with answers for the Environmental Systems subject (AM.II.G) of the FAA Aviation Mechanic Airframe oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.
What is cabin differential pressure, and why does a mechanic care about it?
What the examiner listens for
- The difference between air pressure inside the cabin and outside the cabin
- It is the pressure load the fuselage structure has to carrybonus
- Each aircraft has a maximum allowable differentialbonus
A good answer: Cabin differential pressure is cabin pressure minus ambient pressure. It is the load on the pressure vessel, so the pressurization system and safety valves must keep it below the aircraft's maximum.
Likely follow-up: What is meant by cabin altitude?
Reference: FAA-H-8083-31B Ch. 16, Pressurization Terms
On a pressurized aircraft with air cycle air conditioning, how is warm air for the cabin obtained?
What the examiner listens for
- Hot bleed air is mixed with cold air from the air cycle machine
- The mix is adjusted to get the selected cabin temperaturebonus
A good answer: Warm cabin air is made by mixing hot bleed air with the cold air coming from the air cycle machine's expansion turbine, in the proportion needed for the selected temperature.
Likely follow-up: What component does the mixing, and what controls it?
Reference: FAA-H-8083-31B Ch. 16, Aircraft Heaters
A combustion heater's overheat switch has tripped. What does the crew see, and can the heater simply be restarted?
What the examiner listens for
- A light illuminates in the flight deckbonus
- The heater cannot be restarted until maintenance determines the cause
- The switch cuts off fuel to the heaterbonus
A good answer: The overheat switch cuts fuel to the heater and turns on a light in the flight deck. The heater cannot be restarted until maintenance has determined the cause of the overheat.
Likely follow-up: What other switch shuts off fuel if there is not enough ventilating airflow?
Reference: FAA-H-8083-31B Ch. 16, Combustion Heaters, Safety Features
When does a vapor cycle system have to be evacuated before it is recharged, and what does evacuation accomplish?
What the examiner listens for
- Whenever the system has been opened or has lost its charge
- Evacuation removes moisture from the system
- A vacuum pump lowers the pressure so the water boils offbonus
A good answer: Any time the system is opened, the refrigerant is lost, or the charge drops below atmospheric pressure, it must be evacuated before recharging. A vacuum pump lowers system pressure so any water vaporizes and is drawn out.
Likely follow-up: What can a few drops of moisture do at the expansion valve?
Reference: FAA-H-8083-31B Ch. 16, Evacuating the System
Which component actually controls the pressure in a pressurized cabin, and how?
What the examiner listens for
- The outflow valve
- Its position controls how much air leaves the cabinbonus
- It is positioned by the cabin pressure regulator or controllerbonus
A good answer: The outflow valve. Air is continuously supplied to the cabin, and the pressure regulator or controller positions the outflow valve to let more or less air out; valve position determines cabin pressure.
Likely follow-up: Where is the outflow valve normally located?
Reference: FAA-H-8083-31B Ch. 16, Control of Cabin Pressure
On a walk-around you notice the green oxygen blowout disc on the fuselage is missing. What does that mean?
What the examiner listens for
- The oxygen system relief valve has opened and discharged overboard
- The cause must be investigated before flightbonus
A good answer: A missing green disc means the high-pressure relief valve has opened and vented oxygen overboard. The cause has to be investigated, and the system serviced, before flight.
Likely follow-up: What could cause oxygen cylinder pressure to rise enough to open the relief valve?
Reference: FAA-H-8083-31B Ch. 16, Oxygen Plumbing & Valves
Why must oil and grease be kept away from oxygen systems, and what does that mean for your hands and tools?
What the examiner listens for
- Pure oxygen combined with petroleum products can cause a fire or explosion
- Hands, clothes, and tools must be clean and grease-freebonus
- Use only lubricants and sealants approved for oxygenbonus
A good answer: Pure oxygen reacts violently with petroleum products and can explode or burn. Hands, clothing and tools must be clean and free of grease, and only oxygen-approved lubricants, sealants and cleaners may be used.
Likely follow-up: What kind of thread sealant may be used on tapered oxygen pipe fittings?
Reference: FAA-H-8083-31B Ch. 16, Prevention of Oxygen Fires or Explosions
How should you open the valve on a high-pressure oxygen cylinder, and why?
What the examiner listens for
- Open it slowly
- Oxygen rushing into a low-pressure area heats up rapidlybonus
- That heat can ignite materials, causing fire or explosionbonus
A good answer: Always open oxygen valves slowly. If high-pressure oxygen rushes into a low-pressure line it heats up from rapid compression, and in pure oxygen that heat can ignite even metal and cause a fire or explosion.
Likely follow-up: How are oxygen shutoff valves designed to help with this?
Reference: FAA-H-8083-31B Ch. 16, Oxygen Plumbing & Valves
These are 8 of the 37 questions MockDME has for this subject. The other 29 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.
Get the app when it launches
MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.
We use your address only for this one launch email and delete it afterwards. Privacy policy.
Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.