A&P oral questions / Powerplant
Engine Lubrication Systems: A&P oral exam questions
4 practice questions with answers for the Engine Lubrication Systems subject (AM.III.G) of the FAA Aviation Mechanic Powerplant oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.
What is ashless dispersant oil, and what does the dispersant additive do for a piston engine?
What the examiner listens for
- Mineral-based oil with nonmetallic additives that leave no ash depositsbonus
- The dispersant holds contaminant particles in suspension
- The particles are then trapped by the filter or drained at the oil changebonus
- It is not a detergent and does not clean out existing depositsbonus
A good answer: Ashless dispersant oil is mineral-based oil with nonmetallic, non-ash-forming additives. The dispersant keeps dirt and combustion particles suspended in the oil so the filter can trap them or they leave with the oil at the next change.
Likely follow-up: How is an ashless dispersant oil identified in its grade designation?
Reference: FAA-H-8083-32B Ch. 6, Types of Oil
What is the purpose of the oil filter bypass valve?
What the examiner listens for
- It lets oil go around the filter if the filter is clogged
- It also opens when cold, congealed oil cannot get through the filterbonus
- Unfiltered oil is better than no oil reaching the enginebonus
A good answer: If the filter is clogged, or the oil is congealed on a cold start, the spring-loaded bypass valve opens and lets unfiltered oil flow around the filter to the engine. Dirty oil is better than no lubrication.
Likely follow-up: Where is a full-flow filter located in the system relative to the pump and the bearings?
Reference: FAA-H-8083-32B Ch. 6, Oil Filters
At an oil change, how do you inspect a spin-on oil filter, and what are you looking for?
What the examiner listens for
- Cut the filter can open and remove the element
- Unfold and examine the filter media for metal particlesbonus
- Metal particles, shavings, or flakes indicate abnormal engine wear
- Also check the pressure or suction screens for metalbonus
A good answer: The spin-on filter is cut open with a filter cutter and the element is removed and unfolded. I examine what the media trapped, looking for metal particles, shavings, or flakes, which indicate premature or excessive wear and call for finding the source.
Likely follow-up: How could you tell whether particles from the filter are ferrous?
Reference: FAA-H-8083-32B Ch. 6, Oil Filter Removal Canister Type Housing; Oil Filter/Screen Content Inspection
An engine has run several hundred hours on straight mineral oil. What is the risk in switching to ashless dispersant oil, and how do you make the change?
What the examiner listens for
- The dispersant oil can loosen sludge deposits and plug oil passages
- Do not add it to the mineral oil: drain, then fill with ashless dispersant
- Change the oil early and check filters and screens for sludgebonus
A good answer: Ashless dispersant oil can loosen sludge that then plugs oil passages. So you do not add it to straight mineral oil: drain the mineral oil, fill with ashless dispersant, change it again after no more than about five hours, and keep checking filters and screens for sludge.
Likely follow-up: Is it good practice to mix different approved brands of turbine oil?
Reference: FAA-H-8083-32B Ch. 6, Draining Oil
These are 4 of the 14 questions MockDME has for this subject. The other 10 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.
Get the app when it launches
MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.
We use your address only for this one launch email and delete it afterwards. Privacy policy.
Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.