A&P oral questions / Airframe

Communication and Navigation Systems: A&P oral exam questions

8 practice questions with answers for the Communication and Navigation Systems subject (AM.II.I) of the FAA Aviation Mechanic Airframe oral exam. Say your answer out loud first, the way you will in front of the DME, then open the answer and check which points you covered.

AM.II.I.K1 · Knowledge · Radio operating principles

In radio communication, what is a carrier wave, and how does it end up carrying voice or data?

What the examiner listens for
  • The carrier wave is the basic radio frequency wave produced by the transmitterbonus
  • It is modulated, meaning altered, by the information signal
  • The receiver demodulates it to recover the informationbonus
  • Common methods are amplitude modulation and frequency modulationbonus

A good answer: The carrier wave is the basic radio frequency wave, which by itself carries no information. The voice or data signal modulates the carrier, by changing its amplitude or its frequency, and the receiver demodulates it to recover the original signal.

Likely follow-up: What is the difference between amplitude modulation and frequency modulation?

Reference: FAA-H-8083-31B Ch. 11, Loading Information onto a Radio Wave

AM.II.I.K3 · Knowledge · Antenna, static discharge wicks, and avionics identification, inspection, and mounting requirements

A quarter-wave VHF comm antenna is being installed on a fabric or composite skinned aircraft. What extra provision does it need that a metal aircraft would not, and why?

What the examiner listens for
  • A ground plane must be installed under the skin at the antenna
  • On a metal aircraft the skin itself acts as the ground plane, supplying the other quarter wavelengthbonus
  • It can be made of aluminum sheet, foil, or radial wiresbonus

A good answer: A quarter-wave Marconi antenna depends on a conductive surface under it to act as the other quarter wavelength. On a metal aircraft the skin does that, but on fabric or composite skin a ground plane of thin aluminum, foil, or radial wires has to be installed under the skin at the antenna base.

Likely follow-up: How are most VHF communication antennas polarized?

Reference: FAA-H-8083-31B Ch. 11, Marconi Antenna

AM.II.I.K7 · Knowledge · Emergency locator transmitter (ELT)

How often must an ELT be inspected, and what four things does the regulation require you to inspect?

What the examiner listens for
  • Within 12 calendar months after the last inspection
  • Proper installationbonus
  • Battery corrosionbonus
  • Operation of the controls and crash sensor, and sufficient signal radiated from the antennabonus

A good answer: Under 14 CFR 91.207, the ELT must be inspected within 12 calendar months of the last inspection for proper installation, battery corrosion, operation of the controls and crash sensor, and a sufficient signal radiated from its antenna.

Likely follow-up: What do you record after the inspection?

Reference: 14 CFR 91.207(d)

AM.II.I.K9 · Knowledge · VHF omnidirectional range (VOR) theory, components, and operation

How would you recognize a typical VOR antenna on a light aircraft, and how is it polarized?

What the examiner listens for
  • It is a V-shaped dipole antenna
  • It is horizontally polarized
  • It is often mounted on the vertical fin or top of the fuselagebonus

A good answer: The usual VOR antenna is a V-shaped dipole, and it is horizontally polarized. On light aircraft it is commonly seen on the vertical fin or on top of the fuselage.

Likely follow-up: How does that differ from a typical VHF communication antenna?

Reference: FAA-H-8083-31B Ch. 11, VOR Navigation System

AM.II.I.K14 · Knowledge · Weather radar

How does on-board weather radar detect weather, and what do the display colors tell the crew?

What the examiner listens for
  • It transmits radio waves that bounce back from precipitation
  • Denser precipitation gives a stronger returnbonus
  • Green is light, yellow is medium, red is heavy returnsbonus

A good answer: Weather radar transmits radio energy and receives the echoes that bounce off precipitation; clouds alone give no return. The denser the precipitation, the stronger the return, shown as green for light, yellow for medium, and red for heavy, with magenta for extreme precipitation or turbulence.

Likely follow-up: Does weather radar show clouds that contain no precipitation?

Reference: FAA-H-8083-31B Ch. 11, Weather Radar

AM.II.I.K18 · Knowledge · Stability augmentation systems (SAS) (Rotorcraft)

What is a stability augmentation system on a helicopter, and how does it make its control inputs?

What the examiner listens for
  • It helps stabilize the helicopter in flight and in a hover, reducing pilot workload
  • A computer senses attitude and commands electric actuators that make inputs to the hydraulic servosbonus
  • The pilot can override or disconnect it at any timebonus

A good answer: A stability augmentation system helps stabilize the helicopter in flight and in a hover, which reduces pilot workload. A computer senses helicopter attitude and commands electric actuators that make small inputs to the hydraulic flight control servos, and the pilot can override or disconnect it at any time.

Likely follow-up: What is the simplest form of stability augmentation, and how does it work?

Reference: FAA-H-8083-31B Ch. 2, Stability Augmentation Systems (SAS)

AM.II.I.K21 · Knowledge · Transponder/encoder system

You need to change the code on a transponder while the aircraft is powered up in the hangar. How do you do it safely, and why?

What the examiner listens for
  • Put the transponder in OFF or STANDBY before changing the code
  • A transponder on the ground can still be interrogated and replybonus
  • Passing through emergency codes such as 7500, 7600, or 7700 could trigger a false alertbonus

A good answer: I would select the code with the transponder in OFF or STANDBY. Being in a hangar or on the ramp does not stop it from being interrogated and replying, and inadvertently transmitting an emergency or reserved code such as 7500, 7600, or 7700 would be taken seriously by ATC.

Likely follow-up: Which transponder codes are reserved for hijack, radio failure, and emergency?

Reference: FAA-H-8083-31B Ch. 11, Transponder Tests and Inspections

AM.II.I.R3 · Risk management · Wire harness routing

What precautions apply when routing and securing a coaxial antenna cable?

What the examiner listens for
  • Names at least two of: no sharp bends or kinks, secured firmly along its length, not routed or tied with other wire bundles
  • It is secured at intervals of about 2 feetbonus
  • Bends respect the minimum bend radius in the installation databonus

A good answer: Coax should be secured firmly along its length about every two feet, it should not be routed with or tied to other wire bundles, and it must never be kinked or bent sharply: keep to the minimum bend radius given in the installation data, because coax can be damaged inside with nothing showing outside.

Likely follow-up: Why is the length of the coax critical for transponder and DME installations?

Reference: FAA-H-8083-31B Ch. 11, Coaxial Cable

These are 8 of the 39 questions MockDME has for this subject. The other 31 are in the app, where the examiner voice asks, you answer by voice, and your answer is graded point by point.

Get the app when it launches

MockDME for iPhone asks these questions out loud, listens to your spoken answer, and tells you which points you covered and which you missed. One email on launch day, nothing else.

We use your address only for this one launch email and delete it afterwards. Privacy policy.

Practice questions written from the Aviation Mechanic Airman Certification Standards (FAA-S-ACS-1) and the FAA handbooks cited under each answer. They are not the examiner's actual questions: your DME picks those. Found an error? Tell us and we will fix it.

All 40 subjects